Removing And Refitting The Door Panels - Bosch HGL128I.0R Instruction Manual

Appliance door
en
Attaching the door
Reattach the oven door in the reverse sequence to
removal.
When attaching the oven door, ensure that both
1.
hinges are inserted straight into the opening
(figure A).
The notch on the hinge must engage on both sides
2.
(figure B).
Fold back both locking
3.
levers (figure C). Close the oven door.
:
Warning – Risk of injury!
If the oven door falls out accidentally or a hinge snaps
shut, do not reach into the hinge. Call the after­sales
service.

Removing and refitting the door panels

The glass panels can be removed from the oven door
to allow more thorough cleaning.
Removal
Detach the oven door and lay it on a cloth with the
1.
handle facing down.
Pull off the cover at the top of the oven door. Press
2.
in the tabs on the left and right using your fingers
(fig. A).
Lift the top panel up and pull it out (fig. B).
3.
26
Lift the panel up and pull it out (fig. C).
4.
Clean the panels with glass cleaner and a soft cloth.
:
Warning – Risk of injury!
Scratched glass in the appliance door may develop into
a crack. Do not use a glass scraper, sharp or abrasive
cleaning aids or detergents.
Installation
During installation, make sure that the lettering "top
right" is upside down at the bottom left.
Insert the panel at an angle towards the back
1.
(fig. A).
Insert the top panel at an angle towards the back
2.
into the brackets. The smooth surface must face
outwards. (fig. B).
Put the cover back in
3.
place and press on it.
Attach the oven door.
4.
Do not use the oven again until the panels have been
correctly installed.