Table of Contents
Advertisement
Available languages
Available languages
Important Safety Instructions
You must always observe basic precautions when using the wine cabinet, including:
1.
Only use your wine cabinet for intended purposes, as described in this guide.
2. Never unplug the wine cabinet by pulling out the power cord, grip the plug firmly and pull straight
out to remove from wall socket.
3.
Immediately repair or replace any worn or damaged cord, never use a cord that is split or which
shows signs of wear along its length or on its ends.
4.
Do not allow children to climb on, sit on or stand on the wine cabinet, nor hang from its shelves.
They could damage the cabinet.
5.
Do not use an extension cord.
WARNING: Before you throw away your used refrigerator or freezer:
6.
A. Take off the door.
B. Leave the shelves in place so that children may not easily climb inside.
1. Nominal voltage/Frequncy:220~240V~/50Hz;
2. Standard socket with earth connection(12~16A,250V~)
3. If the power cord is damaged, or the plug does not match the socket, and the socket is not
equipped with an earth connection, etc, you must have it checked or replaced by a qualified
electrician to prevent any risks.
1. When you receive the cabinet, make sure when you unpack it there is no flaws in its external
appearance (from shocks, deformation, etc.)
2. Open the door and check all interior fittings and supplied items if are all complete (shelves,
instruction, control panel, etc.) Please install it according to the following points if the shelves or
shelf brackets fall off during transit.
3. Carry your wine cabinet to the final place to see if there is no problem with it after checking.
Observe the following when placed:
A) Ensure that there is a minimum of 5cm between your wine cabinet and the left & right wall;
leaving a space of at least 8cm between the back cabinet and the wall.
B) Position the wine cabinet on a flat level surface, if not, adjust the feet of wine cabinet to keep
level.
4. Away from sources of heat and high humidity areas (laundry room and bathroom, etc).
5. Do not tilt it at an angle of more than 45° when move the cabinet. Allow a minimum 10- minute
interval between transit and re-starting.
6. Make sure the ventilation is free if you wish to install your cabinet into a worktable, otherwise, it
will reduce the effect of usage.
The temperature setting of wine cabinet:
1.
The digital tube on the control panel indicates the temperature, the left digital tube indicates the
temperature and the temperature indicating range is 5℃ ~22℃ (40℉-72℉）,the right ones
indicates the actual temperature of inner cabinet, and the range is 0~37℃ (32℉-99℉)
2.
The temperature setting range of cabinet is 5℃ ~22℃ (41℉-72℉)
3.
Customers can reset the temperature according to their actual demands. The wine cabinet will
turn on and the indicator will turn on until the desired temperature is achieved.
9
Power Supply Connection
Wine Cabinet Installation
Temperature Setting
Advertisement
Table of Contents
