Advertisement
5. MAINTENANCE
WARNING! Disconnect drill from air supply before changing accessories, servicing or
performing maintenance. Replace or repair damaged parts. Use genuine parts only.
Unauthorised parts may be dangerous and will invalidate the warranty.
5.1.
If the air supply does not have an oiler, lubricate the air drill daily with a few drops of Sealey
air tool oil dripped into the air inlet to
prolong its life.
5.2.
Clean the drill after use. DO NOT use worn, or damaged bits.
5.3.
Loss of power or erratic action may be due to the following:
a) Excessive drain on the air line. Moisture or restriction in the air pipe. Incorrect size or
type of hose connectors. To remedy, check the air supply and follow instructions in
chapter 3.
b) Grit or gum deposits in the drill may also reduce performance. If your model has an air
strainer (located in the area of the air inlet), remove the strainer and clean it. Flush the
drill out with gum solvent oil or an equal mixture of SAE No 10 oil and paraffin.
Allow to dry before use.
5.4.
For a full service contact your local Sealey service agent.
5.5.
When not in use, disconnect from air supply, clean drill and store in a safe, dry,
childproof location.
Risk of Hand Arm Vibration Injury
10mm Straight Air Drill model no. SA232 when operated in accordance with these instructions
and tested in accordance with EN 28662-2: 1994 results in the following vibration emission
declared in accordance with
BS EN12096: 1996.
Measured vibration emission value: . . . . . .1.0m/s
Uncertainty: . . . . . . . . . . . . . . . . . . . . . . . . .0.4m/s
These values are suitable for comparison with emission levels of other tools that have
been subject to the same test.
This tool may cause hand-arm vibration syndrome if its use is inadequately managed.
Recommended Measures to reduce risk of hand-arm vibration syndrome:
This item represents a low Hand Arm Vibration risk to users. The calculated minimum usage
period exceeds 8 hours. We recommend appropriate safety equipment is utilised and regular
breaks for the operator are employed to reduce any residual risk of fatigue or repetitive strain
injury.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
2
2
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
www.sealey.co.uk
01284 757500
Web
01284 703534
sales@sealey.co.uk
email
SA232
Issue: 2 - 05/11/09
Advertisement
