Advertisement
2. Attach the cross bar (A) to the outlet box by using two mounting screws (B).
3. Make the bottom of the fixture upward, gently place four glass panels into the metal
frame, then press the clips to secure the glass panels.(Fig.1)
4. Pull out the source wires from the outlet box. Make wire connections using wire
connectors (C) as follows:
---Connect the hot wire (usually black insulation) from the fixture to the black wire
from the power source.
---Connect the neutral wire (usually white insulation) from the fixture to the white
wire from the power source.
---Attach the fixture grounding wire (usually green insulation or bare wire) to the
cross bar (A) with the green grounding screw (E), and then connect it to the
house grounding wire with the wire connector (C).
Carefully put the wires back into the outlet box.
5. Attach the fixture to the cross bar (A) by inserting headless screws (D) into holes on back plate, and then secure it with
two rubber pads (H) and two ball nuts (G).
NOTE: With silicone caulking compound,caulk complete around the back plate meets with the wall surface to
prevent water from seeping into the outlet box.
6. Install a bulb (not included). See relamping label at socket area or packaging for maximum allowed wattage.
Turn on the power at fuse or circuit box.
Operation the Unit Without Photocell
Photocell
Black wires From Photocell
White Wires From Photocell
Red Wires From Photocell
Wires From Fixture
1. Turn off the power at the fuse or circuit box before starting installation.
2. Loosen the wire connector connected with the wires from photocell. (See Fig.2)
Note: Do not move the photocell to prevent water from seeping into the outlet box.
3. Take a white pigtail and black pigtail and make wire connections using wire connector (C): (See Fig.3)
a. The black wire from the fixture to one end of the black pigtail.
b. The white wire from the fixture to one end of the white pigtail.
c. The other end of the black pigtail to the black wire from the power source.
d. The other end of the white pigtail to the white wire from the power source.
Put all wires back into the back plate of the fixture.
Turn on the power at fuse or circuit box.
Wire Connector
White Pigtail
Fig. 2
Glass Panel
Clip
Metal
Frame
Wires From Fixture
Wires From
Main Power
Pigtail
Wire Connector (C)
Fig .3
181204
Fig.1
Advertisement
