Toro 03638 Operator's Manual page 19

Figure 31
1. Bedbar bolt
2. Nut
Assembling the Bedbar
1. Install the bedbar, positioning the mounting ears
between the washer and bedbar adjuster.
2. Secure the bedbar to each side plate with the
bedbar bolts (nuts on bolts) and the 6 washers.
Note:
Position a nylon washer on each side
of the side-plate boss. Place a steel washer
outside each of the nylon washers
3. Torque the bedbar bolts to 37 to 45 N∙m (27 to
33 ft-lb).
Note:
Tighten the locknuts until the outside
steel washer stops rotating and the end play is
removed but, do not overtighten or deflect the
side plates. Washers on the inside may have a
gap.
4. Tighten the spring tension nut until the spring is
collapsed, then back off 1/2 turn
Figure 32
1. Spring tension nut
g027176
3. Steel washer
4. Nylon washer
(Figure 31).
(Figure 32).
g006505
2. Spring
19