Dranetz HDPQ-DN-MVSTR Quick Reference Manual page 23

Hdpq datanode with terminal block voltage and hypertronic current connectors

Table of Contents

WARNING

To reduce the risk of fire, electric shock, or physical

injury, it is strongly recommended that connections be

made with all circuits de-energized and current

carrying conductors fused. If it is necessary to make

connections on energized circuits, these must be

performed by Qualified Personnel ONLY with proper

Personal Protective Equipment.

To avoid the risk of electric shock or burns, always

connect the safety (or earth) ground before making

any other connections.

To reduce the risk of fire, electrical shock, or physical

injury, it is strongly recommended to fuse the voltage

measurement inputs.

Fuses must be located as close to circuit connection

as possible to maximize protection.

For continued protection against risk of fire or shock

hazard, replace only with same type and rating of

recommended fuse. Use only fast blow type fuse

which is rated 600V. Recommended fuse type is

Littelfuse, part number KLKD.300 rated 600V AC/DC,

0.3A fast blow or Dranetz Fuse Voltage Adapter FVA-

1K.

Do not replace fuse again if failure is repeated.

Repeated failure indicates a defective condition that

will not clear with replacement of the fuse. Refer

condition to a qualified technician.

Table of Contents