INSTALLATION Warning : If in doubt, the installation of the infrared motion sensor light should be carried out by a qualified electrician. Before you begin, please verify the contents of this package. It should contain the following parts: LIST PARTS NAME QUANTITY LIST PARTS NAME...
1. Turn off the power at the main fuse box in your home(see Fig. 3). 2. Fix metal bracket on the wall with 2 W ood Screws (not included). 3. Fix halogen lamp to metal bracket with attached hardware. 4. Strip sheath and insulation of cable. Let conductors expose approximate 6 mm.
Page 4
2. Before mounting the sensor on the wall or ceiling, please refer the figures below to prevent INCORRECT installation. MOUNT ON STABLE SURFACE AIM SENSOR DOWNWARD TO REDUCE RANGE DON'T EXPOSE TO RAIN OR AVOID REFLECTED LIGHT FROM BRIGHT SURFACES ROOF RUNOFF MORE SENSITIVE TO MOVEMENT POSITION SENSOR EXACTLY LEVEL...
Page 5
Adjustments: Time(¾) : The detector has an adjustable “Time ON” control from 3 sec. minimum to a maximum of 10 minutes (approx). Timer starts working after the last movement is detected. While there is movement from a heat source in the detecting area the lighting will remain on and the time will keep resetting.
Lights Permanently Off: Turn the control switch OFF. Light Permanently ON (Manual Override): By flipping the connected power switch Off-On twice quickly, it will change from Auto Mode to PERMANENTLY ON Mode. The detector will return to “Auto Mode” i.e. light will go off automati- cally after two hours or by flipping power switch Off-On once instead.
Page 7
Due to our policy of continuous improvement we reserve the right to change specification without prior notice. Errors and omissions excepted. These instructions have been carefully checked prior to publication. However, no responsibility can be accepted by Challenger for any misinterpretation of these instructions.