Directions For Use - Guardian H8000 Use & Care Instructions Manual

DIRECTIONS FOR USE

SET UP
Select a firm, level, flat location - at least six inches (15 cm) from any wall or object for proper air flow.
Place the humidifier on a water-resistant surface, as water can damage furniture and some flooring.
Do not place unit directly on carpet, towels, blankets or other absorbent surfaces.
Guardian Technologies will not accept responsibility for damage caused by water spillage.
FILLING -
Make sure unit is unplugged.
1. Separate the tank from the base of
the unit.
3. Pour cool, clean water directly into
the tank. Do not pour anything but
water into the tank.
5. Attach tank to base of unit and plug in
E-6
2. Flip over water tank and open the
tank lid, turning it to the left
4. Close the tank lid, turning it to the right.
It is important to FIRMLY secure cap
after filling the tank with water.
6. Extension Wands
If desired, assemble extension wands by
fitting ends together. Remove mist cap and
store for use without wands. Then attach
wands to humidity spout. The wands will
extend the mist to a higher level in the air
to help disperse throughout the room.
DIRECTIONS FOR USE
7. Power Button
Before turning on make sure there is
water in the unit. Press the Power button.
%
9. Water Level Window &
Auto Shut Off Feature
The tank includes a water level window
so you can easily see when it is time to
refill with water. The unit will automatically
shut off and a low water icon will blink on
the display panel if the water level is too
low. If this happens, unplug the unit, remove
the tank and refill.
%
8. Select Desired Settings
See"Control Operation" section for available
unit functions. Note: When you power "on"
the humidistat reading range is from 15% to
90%. If the room humidity is below 15%, the
display reading will flash.
E-7