Installing A 1 Gbps Iscsi 4-Port Host Interface Adapter - IBM Storwize V3700 Quick Installation Manual

7. Check that the host interface adapter is installed squarely in its slot and tighten
8. Reinstall the SFP transceivers that were removed in step 1 on page 30. To install

Installing a 1 Gbps iSCSI 4-port host interface adapter

If you purchased an FC ACHL 1 Gbps iSCSI 4-port host interface adapter that was
not pre-installed for you, you must install it in the node canister.
Before you begin
The 1 Gbps iSCSI 4-port host interface adapter is installed in the node canisters in
the control enclosure. If your control enclosure has two node canisters, you must
install the same options in both canisters. Do not start installation until you have
two of the 1 Gbps iSCSI 4-port host interface adapter options.
Procedure
To install the host interface adapter, complete the following steps.
1. Loosen the retaining thumbscrew 1 as shown in Figure 20 on page 33.
32
Storwize V3700: Quick Installation Guide
the retaining thumbscrew 1 .
a transceiver, push it fully into the port and close the release handle.