Kenmore 111.22142 Use & Care Manual page 11

11. Carefully remove the plastic caps that
cover the two door handle braces.
Remove the flat head screws from the
braces and remove handle. Remove the 4
round head screws from door right edge.
Reattach the 4 round head screws to the
left door edge into the holes exposed
from removing the brace screws.
12. Use the removed brace flat head screws
to attach the handle to the right edge of
door into the holes exposed from
removing the 4 round head screws.
Insert the two tabs on the narrow end of
the cap into the slots on the brace, and
then snap the wide end down into place.
13. Once the handle is installed on the right
side of the cabinet, the door reversal
procedure is complete. Open and close
the door to check that it swings freely
and closes securely NOTE: Set the
leveling legs so that the front of the
cabinet is ¼˝ higher than the back to
prevent the door fromaccidental
opening.
11