Miele KWT 6422 iG Operating And Installation Instructions page 49

Display warnings
Message
The alarm symbol  is
lit in the display and
both sensors for the
wine conditioning zones
are flashing in the con-
trol field. Furthermore,
an audible alarm is also
sounding.
The alarm symbol  is
flashing in the display,
and the sensor for one
of the wine conditioning
zones is also flashing.
An alarm tone is also
sounding.
The Change Active
AirClean filter symbol
 is lit up.
A dash is lit up up/flash-
ing in the display.
"F0", "F1", "F8","E1",
"E2", "E7" or "E8" ap-
pears in the display.
Cause and remedy
The door alarm has been activated.
 Close the appliance door. Both sensors for the
wine conditioning zones and the alarm symbol 
will go out and the audible alarm will stop.
The temperature in the zone concerned has risen
higher or fallen lower than the temperature set.
Possible reasons for this include:
– The appliance door has been opened too fre-
quently.
– The ventilation gaps have been blocked.
– A prolonged power cut (power outage) has oc-
curred.
 Rectify the cause of the alarm. The alarm sym-
bol  goes out and the sensor for the affected
wine conditioning zone lights up again constantly.
The alarm will stop.
This is the reminder to change the Active AirClean fil-
ter.
 Replace the Active AirClean filter and then confirm
the filter change in settings mode (see "Active
AirClean Filter").
Only temperatures within the range the wine condi-
tioning unit can display will be shown.
There is a fault.
 Call Service.
Problem solving guide
49