Table of Contents
Advertisement
3
Connect the power-adapter port cable to the system board.
4
Connect the coin-cell battery cable to the system board.
5
Connect the keyboard backlit cable to the system board and close the latch to secure the cable.
6
Connect the keyboard cable to the system board and close the latch to secure the cable.
7
Connect the touchpad cable to the system board and close the latch to secure the cable.
8
Connect the fingerprint-reader cable to the system board and close the latch to secure the cable.
9
Connect the speaker cable to the system board.
10
Connect the I/O-board cable to the system board and close the latch to secure the cable.
11
Adhere the tape that secures the I/O-board cable to the system board.
12
Replace the screw (M2x4) screw that secures the right display hinge to the system board.
13
Replace the screw (M2x4) that secures the display-cable bracket to the system board.
14
Replace the screw (M2.5x3.5) screw that secures the USB Type-C port bracket to the system board.
Next step
1
Install the
power-adapter
2
Install the
display
assembly.
3
Install the
heat
sink.
4
Install the fan.
5
Install the
WLAN
card.
6
Install the
M.2 2280 solid-state drive
7
Install the battery.
8
Install the
base
cover.
9
Follow the procedure in
Display bezel
Removing the display bezel
Prerequisites
NOTE:
This procedure is not applicable to computers shipped with a WWAN configuration.
1
Follow the procedure in
2
Remove the
base
cover.
3
Remove the battery.
4
Remove the
WLAN
card.
5
Remove the
display
assembly.
About this task
The following image indicates the location of display bezel and provides a visual representation of the removal procedure.
48
Removing and installing components
port.
or
M.2 2230 solid-state
After working inside your
computer.
Before working inside your
drive, whichever applicable.
computer.
Advertisement
Table of Contents
