Filling The Engine With Oil; Assembling The Grass Bag - Toro Super Recycler 20837 Operator's Manual

3

Filling the Engine with Oil

No Parts Required
Procedure
Important:
Your machine does not come with oil
in the engine. Before starting the engine, fill the
engine with oil.
Engine Oil Specifications
Engine oil capacity
Oil viscosity
API service classification
1. Move the machine to a level surface.
2. Remove the dipstick by rotating the cap
counterclockwise and pulling it out
1. Full
2. High
3. Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
4. Wait 3 minutes for the oil to settle in the engine.
5. Wipe the dipstick clean with a clean cloth.
6. Insert the dipstick into the oil-fill tube, but do not
screw it in, then remove the dipstick.
0.55 L (18.6 fl oz)
SAE 30 or SAE 10W-30
detergent oil
SJ or higher
(Figure
Figure 6
3. Low
7. Read the oil level on the dipstick
•
If the oil level on the dipstick is too low,
carefully pour a small amount of oil into the
oil-fill tube, wait 3 minutes, and repeat steps
5 through
the correct level.
•
If the oil level on the dipstick is too high, drain
the excess oil until the oil on the dipstick is
at the correct level; refer to
Engine Oil (page
Important:
low or too high and you run the engine, you
may damage the engine.
8. Install the dipstick into the oil-fill tube securely.
4

Assembling the Grass Bag

6).
No Parts Required
Procedure
1. Slip the grass bag over the frame as shown in
Figure 7.
g238622
1. Handle
2. Frame
Note:
Do not slip the bag over the handle
(Figure
2. Hook the bottom channel of the bag onto the
bottom of the frame
5
7 until the oil on the dipstick is at
16).
If the oil level in the engine is too
Figure 7
3. Grass bag
7).
(Figure 8).
(Figure 6).
Changing the
g027257