Shutting Off The Engine; Recycling The Clippings; Bagging The Clippings - Toro Super Recycler 20837 Operator's Manual

Shutting Off the Engine

Service Interval: Before each use or daily
To shut off the engine, release the blade-control bar.
Important:
When you release the blade-control
bar, the engine should shut off and the blade
should stop within 3 seconds. If they do not, stop
using your machine immediately and contact an
Authorized Service Dealer.

Recycling the Clippings

Your machine comes from the factory ready to recycle
the grass and leaf clippings back into the lawn.
Note:
The grass bag may remain on the machine
while you are recycling the clippings.
To recycle the clippings, move the bag-on-demand
lever to the R
ECYCLING
Figure 16
1. R position
ECYCLING
position (Figure 16).
2. B position
AGGING

Bagging the Clippings

Use the grass bag to collect grass and leaf clippings
from the lawn.
WARNING
A worn grass bag could allow small stones
and other similar debris to be thrown toward
you or bystanders, resulting in serious
personal injury or death.
Check the grass bag frequently. If it is
damaged, install a new Toro replacement bag.
WARNING
The blade is sharp; contacting the blade can
result in serious personal injury.
Shut off the engine and wait for all moving
parts to stop before leaving the operating
position.
1. Shut off the engine and wait for all moving parts
to stop.
2. Install the grass bag; refer to
Bag (page 11)
lever to the
16.
Installing the Grass Bag
1. Shut off the engine and wait for all moving parts
to stop.
2. Raise and hold up the rear deflector, install the
bag in the notches, and lower the rear deflector
(Figure 17).
g012135
11
Installing the Grass
and move the bag-on-demand
position as shown in
BAGGING
Figure 17
Figure
g014468