Vaxcel T0350 Assembly And Installation Instructions

ASSEMBLY AND INSTALLATION
T0350 T0494
WARNING:
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
Hardware Package (included):
Cross Bar (A)
Mounting Screw (B)
Wire Connector (F)
Outlet Box
House Grounding Wire
Headless Screw (D)
Fixture Grounding Wire
Cross Bar (A)
Green Grounding Screw (C)
Mounting Screw (B)
Lock Nut (E)
IMPORTANT:
The sensor has an excellent photocell function
to enable the light to turn on at dusk and
dawn automatically.
Installation Steps
Turn off the power at fuse or circuit box.
1. Thread two headless screws (D) through the cross bar (A), and then secure them with four lock nuts (E).
Adjust the length of the headless screws (D) if necessary.
Note: Make sure that the headless screws are lined up horizontally to make the fixture level.
2. Attach the cross bar (A) to the outlet box by using two mounting screws (B).
3. Pull out the source wires from the outlet box. Make wire connections using wire connectors (F) as follows:
---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire (usually green insulation or bare wire) to the cross bar (A) with the green
grounding screw (C), and then connect it to the house grounding wire with the wire connector (F).
Carefully put the wires back into the outlet box.
INSTRUCTIONS
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Green Grounding
Headless Screw (D)
Screw (C)
Photocell
Back Plate
Fixture Wire
Rubber Pad(H)
Ball Nut(G)
off at
Wire Connector (F)
Ball Nut (G)
Fixture
Holder
Socket
Socket Ring
Bulb Type A Max.60W
(not included)
Rubber Pad (H)
Shade
181010