Advertisement
5. Attach the shade to the socket, and then secure it with the socket ring.
6. Install a bulb (not included). Check relamping label at socket area or packaging for maximum allowed wattage.
Turn on the power at fuse or circuit box.
Operation the Unit Without Photocell
Photocell
Black Wires From Photocell
White Wires From Photocell
Wires From Fixture
1. Turn off the power at the fuse or circuit box before starting installation.
2. Loosen the wire connector connected with the wires from photocell. (See Fig.1)
Note: Do not move the photocell to prevent water from seeping into the outlet box.
3. Take a white pigtail and black pigtail and make wire connections using wire connectors (F) : (See Fig.2)
a. The black wire from the fixture to one end of the black pigtail.
b. The white wire from the fixture to one end of the white pigtail.
c. The other end of the black pigtail to the black wire from the power source.
d. The other end of the white pigtail to the white wire from the power source.
Put all wires back into the back plate of the fixture.
Turn on the power at fuse or circuit box.
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Cross Bar (A)
Mounting Screw (B)
Wire Connector (F)
A
Red Wires From Photocell
Wire
Connector
White Pigtail
Fig. 1
Green Grounding
Screw (C)
Ball Nut (G)
C
Headless Screw (D)
Rubber Pad (H)
A: 15"
B: 12.25"
C: 23"
Wires From Fixture
Pigtail
Wire Connector (F)
Assembly Kit
5786MM (1 SET) for T0369
5787MM (1 SET) for T0372
5987MM (1 SET) for T0484
5988MM (1 SET) for T0488
181009
Wires From
Main Power
Fig .2
Advertisement
