Rangemaster RMB9048BL/SS User Manual & Installation & Service Instructions page 8

Fig. 3.1
5
4
3
2
1
5
4
3
2
1
Fig. 3.2
Press repeatedly
Fig. 3.3
Fig. 3.4
Press repeatedly
Oven Shelf levels
Always count shelf levels from the bottom upwards (Fig. 3.1)
Programming the Oven
Note: The alarm will cut off after two minutes if it is not
switched off manually.
Setting the clock
• The clock is preset to 12:00, and will revert to this after a
power failure. When the current time indicator is flashing,
touch '-' or '+' . When the correct time is shown on the
display, the clock will set after approximately five seconds
delay.
• To change the clock once it has been set, touch 'M'
repeatedly until the current time indicator flashes (Fig.
3.2).
• Press either the '-' or '+' to set the correct time on the
display (Fig. 3.3). the clock will set after approximately five
seconds delay.
The minute minder
The minute minder can be used when the oven is switched
on or off. It can be set for up to 23 hours and 59 minutes.
To set the minute minder:
• Touch 'M' repeatedly until the minute minder indicator
flashes (Fig. 3.4).
• Then touch '-' or '+' to select the required duration for
the minute minder. When the correct duration shows on
the display, either touch 'M' or wait for approximately five
seconds. The minute minder indicator will remain lit to
confirm the minute minder is on (Fig. 3.5).
• When the countdown is complete, there will be an alert
beep which will continue for two minutes and the minute
minder indicator will flash. To switch off the alert beep,
touch any key.
Note: At the end of the countdown, the minute minder
will not switch off the oven. Remember to turn off the oven
manually.
4