Replacing the front USB cable in the 9008-22L, 9009-22A, or 9223-22H
Learn how to replace the front USB cable in the server.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Latch the USB cable socket into the USB holder. Ensure that the tab on the socket aligns with the
holder. Pinch the tabs (A) as shown in Figure 7 and insert the socket into the opening until the tabs
latch into position.
Figure 7. Installing the front USB cable into the front USB holder
3. Insert the front USB cable into the opening on the front of the system. Replace the screws (A) as
shown in Figure 8 on page 8. Route the cable through the chassis and along the right side of the
system chassis.
Removing and replacing the front USB cable
7