Lock Code; Conductivity - Miele TSB 143 WP Operating Instructions Manual

 Lock code
The code prevents your dryer being
used without your knowledge.
When the code has been activated, you
have to enter the code after switching
the dryer on. Otherwise the dryer can-
not be operated.
Options
 = Off (factory setting)
 = On
If the  option has been selected, after
switching on you will have to enter the
code before you can operate the dryer.
Using the tumble dryer when the PIN
code is activated
After the tumble dryer is switched on,
 will flash in the time display.
The PIN code is ; it cannot be
altered.
 Touch the  sensor control until a 
flashes in the first position.
 Confirm with the Start/Add laundry
sensor control.
 Enter the two other numbers in the
same way.
The tumble dryer is ready for use
after  has been entered and con-
firmed.
Programmable functions
 Conductivity
This programmable function should
only be altered if the water is so soft
that it is likely to cause the electronics
which sense residual moisture in the
laundry to give false readings.
Options
 = Off (factory setting)
 = Low
Important
This programmable function should only
be set if the water used for washing the
laundry is extremely soft with a con-
ductivity reading (electrical conductivity)
of less than 150 μS/cm. Contact your
local water authority for the conductivity
level of your mains water supply.
Make sure that you only activate 
for the condition described above.
Otherwise, drying results can be un-
satisfactory.
75