Transmitter Valet Mode - Directed Electronics Arrow 5 Owner's Manual

3.
The LED status indicator will light steadily if you are entering Valet
Mode and will turn off if you are exiting Valet Mode.
To exit Valet Mode:
1. Turn the ignition on.
2. Within 10-seconds press
n n o o t t e e : : The pin code can be entered after turning the ignition On and the press
and hold the blank key on the PlainView 2 Valet switch for one second.

transmitter valet mode

The operations described in this section refer to transmitter buttons.
Remember, the buttons used in all the instructions in this guide corre-
spond to a Standard Configuration transmitter. This may not be how
your transmitter is set up.
To enter Valet Mode, press
status indicator will light solid if you are entering Valet Mode, or will
turn off if you are exiting Valet Mode.
© 2 0 0 4 d i re c t e d e l e c t ro n i c s , i n c .
After the last digit continue to hold
three seconds.
and
for
once.
simultaneously. The LED
11