Quick Reference Guide - Directed Electronics Automate 552 Owner's Manual

QUICK REFERENCE GUIDE:

To lock/arm using your remote
s To arm the system press
connected). The LED will begin to flash. The Failsafe
prevent the vehicle's starter from cranking if it has been installed. The
vehicle's horn (if connected) will honk and the parking lights will flash
once to confirm arming of the system.
To unlock/disarm using your remote
s To disarm the system press
(if connected). The Failsafe
vehicle's horn (if connected) will honk twice and the parking lights will
flash twice.
Disabling the Failsafe
s Turn on the ignition. Press and release the Valet
onds. The LED will stop flashing and the vehicle should start. Be sure to
check with the installer for the location of the Valet
To remote start the vehicle
s Press
and
connected) and the vehicle will start and run for the programmed
amount of time.
To enter or exit Valet
s Turn the ignition to the "ON" position. Turn the ignition back off. Press
and release the Valet
light steadily if you have entered Valet
repeat the steps above. The LED will turn off when exiting Valet
To activate Panic Mode
s Hold
down for 1 second.
To exit Panic Mode
s Press
on the transmitter.
To disable the remote start system
s To disable the remote start, move the shutdown toggle switch to the OFF
position.
Location of Shutdown Switch______________________________
1999 Directed Electronics, Inc.
©
for one second. The doors will lock (if
for one second. The doors will unlock
®
Starter Kill will be deactivated and the
®
Starter Kill without a transmitter
simultaneously. The parking lights will turn on (if
®
Mode
®
switch within 10 seconds. The status LED will
®
Mode. To exit Valet
®
Starter Kill will
®
switch within 10 sec-
®
switch.
®
Mode,
®
Mode.
21