Table of Contents
Advertisement
The engine may be allowed to run for its pre-programmed time
period, or it can be shut down while running during Timer Mode
operation by pressing Buttons
case, the vehicle will restart every three hours for a total of six
operation cycles. If the system receives a shut-down input while
the engine is running in Timer Mode, the engine will stop, but will
restart, on schedule, again in three hours!
To exit Timer Mode:
Timer Mode can be exited by turning the ignition on with the key
any time the engine is not running. You can also exit Timer Mode
with the remote transmitter by following these steps:
1.
Start the engine by pressing
2.
Press and release
3.
Within two seconds press and release
4.
The engine will shut down and the parking lights will flash
four times to confirm that Timer Mode has been exited. If the
car has already been remote started, skip Step One.
Starter Anti-Grind Circuitry
Whenever the vehicle is remote started, advanced anti-grind cir-
cuitry prevents the starter from engaging, even if the key is turned
to the start position. This prevents damage to the starter motor if
the key is turned to the start position during remote start operation.
NOTE: Anti-grind circuitry only works when the remote start system is
operating the motor and the Failsafe
14
and
again. In either
and
.
.
and
®
Starter Kill relay is installed.
1999 Directed Electronics, Inc.
©
again.
Advertisement
Table of Contents
