Disabling The Remote Start System; Programming Options - Directed Electronics Automate 552 Owner's Manual

Remote start keyless entry system

Table of Contents

Disabling the Remote Start System

This feature allows your system's remote start unit to be tem-

porarily disabled to prevent the vehicle from being remote started

accidentally. This feature is useful if the vehicle is being serviced

or stored in an enclosed area. To disable the remote start, move

the shutdown toggle switch to the OFF position. The switch can

be installed in a location of your choice. Check with your installer

for recommended locations.

LOCATION OF SHUTDOWN SWITCH_________________________

Programming options control your system's normal, operational

set-up. Most options do not require additional parts, but some may

require additional installation labor.

This system's programming options are listed below, with the

factory default settings in bold:

12, 24, or 60 minute run time. Your system can be pro-

grammed to allow the vehicle to run for 12, 24, or 60 min-

utes when remote started or in Timer Mode.

Parking lights flashing or constant. Your system can be pro-

grammed to either flash or to turn on the parking lights con-

stantly during the entire remote start operation.

1999 Directed Electronics, Inc.

Table of Contents