System Board - HP Pro 3005 Disassembly Instructions Manual

Components and parts containing toner and ink,
including liquids, semi-liquids (gel/paste) and toner
Components and waste containing asbestos
Components, parts and materials containing
refractory ceramic fibers
Components, parts and materials containing
radioactive substances
1.3 Markings for plastic parts greater than 25 grams
Plastic Part Name
Oak ROW Main Bezel
Oak ROW Bezel Frame
System Fan Frame
CPU Heatsink Fan
Frame
2.0 Tools Required
List the type and size of the tools that would typically be used to disassemble the product to a point where components
and materials requiring selective treatment can be removed.
Tool Description
Description #1 Torx screwdriver
Description #2 Phillips screwdriver
Description #3 Diagonal cutters (dikes)
Description #4
Description #5
3.0 Product Disassembly Process
3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment:
1.

SYSTEM BOARD:

(1). Remove the access panel: (a)Remove the one screws that secure the access panel to the computer chassis. (see
Figure 1 below) (b)Pull the Access Panel to rear side and take off the Access Panel. (see Figure 2 below)
(2). Remove the front bezel: (see Figure 3 below) a)
Rotate the front bezel and take off.
( 3). Disconnect the power, and data cables from the back of all installed drives.
(4). Disconnect all cables from the system board.
( 5). Remove the heatsink from the system board: (see Figure 4 below) (a)Disconnect the heatsink control cable from the
system board. (b)Loosen the four captive screws that secure the heatsink to the system board. (c)Lift the heatsink from
atop the processor and set it on its side to keep from contaminating the work area with thermal grease.
EL-MF877-00
Template Revision B
Plastic Part
Description
Main front bezel piece
Front bezel frame
Fan Frame
Fan Frame
PSG instructions for this template are available at
Include the cartridges, print heads, tubes, vent
chambers, and service stations.
Weight ISO 11469:2000 Plastic Part
(grams)
150
194
40
28
Release the 3 front bezel snaps on the top side of the bezel. b)
EL-MF877-01
Mark
>ABS<
>ABS<
>PBT-GF30-FR(17)<
>PBT-GF30-FR(17)<
0
0
0
0
Optional:
Photo
Tool Size (if
applicable)
T15
175mm
165mm
Page 2