Rail Base U Replacement; Spring-Loaded Cord Reel Pre-Winding; How To Disassemble The Turbine Nozzle - Panasonic MC-CG487-ZC79 Service Manual

4.6.

Rail base U replacement

1. Remove the screw fixing the rail base U onto the cord reel
partition U.
2. Remove the rail base U from the cord reel partition U.
4.7. Spring-loaded cord reel pre-
winding
1. The cord reel partition U has a spring that pre-winds the
cord reel.
If the cord is not wound, then press the brake arm, and
the cord pre-winding will be loosened.
If you wish to apply pre-winding again, then wind the cord
three turns in the direction of the arrow mark.
* If you wish to release the pre-winding, then make
sure to hold the cord plug.
4.8. How to disassemble the tur-
bine nozzle
4.8.1. Agitator ass'y
1. Rotate the brush cover to unlock it and remove the brush
cover U.
2. Pull up the rotating brush and remove the belt and rotat-
ing brush (complete). (Fig.19)
4.8.2. Separation of the floor nozzle upper
from the floor nozzle lower U
1. Remove the four screws fixing the floor nozzle lower U.
(Fig.20)
2. Remove the floor nozzle lower U.
10