HP ZHAN 66 Pro 14 G3 Maintenance And Service Manual page 69

Hide thumbs Also See for ZHAN 66 Pro 14 G3:

Table of Contents

13.

If it is necessary to replace the WLAN antennas, remove the cables from the clips in the bottom of the

enclosure (1), and then peel the antennas and remove them from the display enclosure (2).

WLAN antennas are available as spare part number L78070-001.

14.

If it is necessary to remove or replace the display/camera cable, use the following steps:

Disconnect the cable from the ZIF connector on the camera module (1).

Pull the cable up to disengage it from the adhesive that secures it to the inside of the enclosure (2),

and then remove the cable from the enclosure (3).

Reverse this procedure to reassemble the display assembly.

Component replacement procedures

Table of Contents