Table of Contents
Advertisement
4.
The display panel is secured to the display enclosure with tape that is installed under the left and right
sides of the panel. To remove the panel, use tweezers to grasp the end of the tape (1). While turning the
tweezers (2), wrap the tape around the tweezers (3) as you continue to pull the tape out from behind
the display panel. You must pull the tape multiple times before it is completely removed.
IMPORTANT:
If the tape tears, do not attempt to pry the panel off the enclosure. Doing so might break
the panel.
The ends of the tape are accessible at both the top and bottom of the display panel.
To avoid tearing the tape, do not pull on it with the sharp end of tweezers.
5.
Rotate the display panel over and place next to the display enclosure (4).
Display panels are available as spare part number L77256-001 for 250-nit panels and L77257-001 for
400-nit panels.
6.
Lift the tape from the connector on the display panel (1), lift the locking lever (2), and then disconnect
the cable from the panel (3).
Component replacement procedures
57
Advertisement
Table of Contents
