Mitsubishi Electric EB-50GU-A Instruction Book page 22

4-3-6. Registering general equipment to a group
(1) To register general equipment to a group, click the [Air
conditioner, Air To Water (PWFY) unit, and general
equipment registration] field next to the target group
name. The [Select Unit Addresses] screen will appear.
Check the radio button next to [General Equipment (via
PAC-YG66DCA)].
Select the device number of the DIDO controller (PAC-
YG66DCA) that is connected to the general equipment
to be registered. The selected number will appear with
a red frame. Also, select contact points to which the
general equipments are connected.
Click again to deselect. The deselected numbers will
appear with a light-gray background.
Note: Each group can contain up to 16 general equipments.
Note: Air conditioners, Air To Water (PWFY) units, and LOSSNAY units cannot be combined with general equipment
in one group. To change the registered units to general equipment in the group to which air conditioners, Air
To Water (PWFY) units, or LOSSNAY units are registered, unregister the air conditioners, Air To Water (PWFY)
units, or LOSSNAY units first.
Note: Each contact of DIDO controller counts as one unit.
Note: General equipment groups cannot include remote controllers or system controllers.
(2) To change the icon, click the right or left arrow.
The selected icon will be displayed on the Web browser.
(3) In the [Allow Operations] section, make the setting to allow or disallow operation.
Select [In batch and on individual group] to allow the operator to turn on or off the general equipments
collectively or by the groups.
Select [On individual group] to allow the operator to turn on or off the general equipments by the groups.
Select [No operations (Monitor only)] to disallow the operator to turn on or off the general equipment.
(4) In the [Monitor] section, select which status will be used to reflect the units' ON/OFF status to the unit
icons on the Condition List screen, accessible via the Web Browser for System Maintenance Engineer.
Select [Output status] to use the status that is sent to the general equipment, and [Input status] to use the
status that is sent from the general equipment.
22