Toshiba RAS-3M26U2AVG-E Service Manual page 91

No. Part name
7) Remove the earth wire of IPDU P.C. board.
IPDU P.C.
6
board
8) Take off fixing screws for IPDU P.C. board.
(Continued)
9) Remove IPDU P.C. board. (3 supporters)
NOTE)
Be careful that IPDU P.C. board is difficult to be
taken out by radiating grease for the heat sink.
10) Mount a new IPDU P.C. board.
NOTE)
• Take note that the compressor lead V:
• Be sure not to forget to attach the Sub heat
Procedure
(Truss head B tight screw Ø4 × 6, 1 pc.).
(Flange nut to fix element Ø3 × 16, 7 pcs.: Pan
head S tight screw to fix P.C. board
Ø3 × 20, 1 pc.)
CN201 (white) and the reactor lead CN05,
CN06 are correctly attached.
(For the compressor lead, the transparent
sleeve is attached to the circular terminal,
and for the reactor lead, the transparent
sleeve is not attached to the circular terminal.)
sink and also the rediating sheet.
(If you apply a little amount of radiating
grease beforehand to the rear side of the
insulation sheet, the attaching work to the
heat sink will become easy.)
Fixing screws
for element
(7 positions)
IPDU P.C. board
fixing screw
IPDU P.C. board
Sub heat sink
- 91 -
FILE NO. SVM-18051
Remarks
Earth screw
Supporters
(3 positions)
Radiating grease
Rediating sheet