DCS BGCU-3036 Installation Instructions Manual page 8

WALL MOUNT FULL BACKGUARD INSTALLATION
6
US
CA
Front Section
Tabs*
*Insure tabs and holes engage to secure top of backguard.
CARE AND MAINTENANCE
This is made of stainless steel. Use the mildest cleaning procedure first. Hot soapy water, rinse and dry. If
the panel has food soil remaining, try a general kitchen cleaner, such as Fantastik®, Simple Green® or Formula
409®. Apply cleaner with a damp sponge, rinse thoroughly and dry. Always scrub lightly in the direction of the
grain. Do not use a steel wool pad, it will scratch the surface. To touch up noticeable scratches in the stainless
steel, sand very lightly with dry 100 grit emery paper, rubbing in the direction of the grain. After cleaning use
a stainless steel polish, such as Stainless Steel Magic®. If the rear top burners are used extensively on high it is
possible for the vertical stainless steel panel to discolor from the burner heat. This discoloration can be removed
by using Revere Ware Stainless Steel Cleaner.
Holes*
Back Section
#8
Self-
tapping
sheet
metal
screws
Fig.05
Rack
Fig.06