Advertisement
TECHNICAL INFORMATION
The installations, conversions and maintenance
operations listed in this part must only be carried
out by authorised personnel. The manufacturer
cannot be held responsible for any damage to
persons or property resulting from an incorrect
installation of the appliance.
The appliance is to be placed directly on the floor
and should not be mounted on a base.
• The safety and automatic adjustment devices of the
appliances may, during its life, only be modified by
the manufacturer or duly authorised supplier.
• This appliance shall be installed only by
authorised personnel and in accordance with
the manufacturer's installation instructions, local
gas fitting regulations, municipal building codes,
electrical wiring regulations, AS 5601 - Gas
Installations and any other statutory regulations.
• Failure to install the appliance correctly could
invalidate any manufactures warranty and lead to
prosecution under the above quoted regulation.
• Before installation, make sure that local distribution
conditions (gas and electrical) are compatible with
the appliance's adjustment. Refer to data label for
gas type.
• As it is not connected to a device for the evacuation
of the products of combustion, it must be installed in
accordance with current regulations and used in a
well ventilated location. Particular attention must be
paid to the regulations on ventilation.
VENTILATION
All rooms require an openable window or equivalent,
while some rooms require a permanent vent in addition
to the openable window.
Ventilation must be in accordance with AS5601 -
Gas Installations. In general, the appliance should
have adequate ventilation for complete combustion
of gas, proper flueing and to maintain temperature of
immediate surroundings within safe limits.
The use of a gas appliance results in production of
heat and moisture in the room in which it is installed.
Ensure that the kitchen is well ventilated; keep
natural ventilation holes open or install a mechanical
ventilation device (mechanical extraction hood).
Prolonged intensive use of the appliance may call for
additional ventilation, for example increasing the level
of mechanical ventilation where present.
UNPACKING YOUR COOKER
• Once the packaging has been removed, thoroughly
check that the appliance is in perfect condition. If
INSTRUCTIONS FOR THE INSTALLER
you have any doubts do not use the appliance and
call our Service Centre.
• Do not move the appliance by the handles.
• Some parts mounted on the appliance are protected
by a plastic film. This protection must be removed
before using the appliance. We recommend slitting
the plastic film along the edges with a sharp knife or
pin.
The packaging materials used (cardboard,plastic
bags, polystyrene foam, nails etc.) must not be
left anywhere within easy reach of children as
they are a potential hazard source.
POSITION
(fig. 14)
The appliance should be positioned in good light and
free from draughts. Any adjoining wall surface situated
within 200 mm from the edge of any hob burner must be
a suitable non-combustible material for a height of 150
mm for the entire length of the hob. Any combustible
construction above the hotplate must be at least 750
mm above the top of the burner and no construction
shall be within 450 mm above the top of the burner.
Where a combustible surface adjacent to the cooker
is less than 200 mm from the nearest burner it may
be protected by a non-combustible protective layer in
accordance with AS5601. The protection must ensure
the surface temperature of the combustible surface
does not exceed 65º C above ambient.
18
1 0
0 m
m
14
Hide quick links:
Advertisement
