Page 25
Spray on surface cleaners should also be avoided.The use of these cleaners can result in the development of rust and corrosion.
Page 26
and can result in the development of rust and corrosion...
Page 27
Oven door style 1: Remove and assemble procedure · Open door fully · Lift up and turn the small levers situated on the two hinges fully back · Grip the door on the two external sides; shut it slowly until door contacts the clips.
Page 34
If the cooker is INSTALLED between two cupboards you must drill a 16mm hole level to the safety chain height on either cupboard as far back as possible, locate the cooker into position and pass the safety chains through the 16mm holes, with the cooker in the final position pull both safety chains and secure them to the inside of the cupboard with two screws on each safety chain.
Page 35
Incorrect Installation Accidental Tipping Chains are provided as a preventative measure against accidental tipping. These chains must be fitted as part of the installers compliance.. Failure for your installer to fit chains in accordance with the relevant installation code will make the installation of your upright cooker non-compliant and class as an illegal installation.
Page 36
Correct Chain Installation Right Side Left Side In order to prevent the oven from tipping forward as shown on the previous page, we need to make sure both chains provided with the oven are used. On the left side of the oven a 16mm drill bit was used to drill through the cabinetry into the adjacent cabinet, as you can see the hole has not been drilled hard up against the wall because there is a 16mm board at the rear of the cabinet.
Page 42
77 Fillo Drive Someerton Victoria 3062 20110331...