Table of Contents
Advertisement
Figure 9: Login screen
3.
After typing the password, the main screen appears as
shown in Figure 10 below.
Figure 10: Main web screen of the industrial managed switch
4.
The switch menu on the left side of the web page permits
access all the functions and status provided by the
industrial managed switch.
Refer to the User Manual for further information about using
the web management interface.
Note: For security purposes, change and memorize the new
password after this first setup.
P/N 1073222-EN • REV C • ISS 01FEB19
Resetting the switch to default
To reset the IP address to the default IP address
"192.168.0.100" and the user password to factory default mode
(default password is "admin"), press the hardware reset button
on the front panel for about 10 seconds. After the device is
rebooted, log in to the management web interface within the
same subnet of 192.168.0.xx and default password. Note that
all the previous setups are erased after the factory default
reset.
Figure 11: Industrial managed switch reset button
Contact information
North America
T
+1 855.286.8889
E
techsupport@interlogix.com
W
www.interlogix.com/support
Latin America
T
+1 561-998-6114
E
latam@interlogix.com
Europe, Middle East, and Africa
W
Select Contact Us at www.firesecurityproducts.com
Australia
E
security.tech.support@interlogix.com.au
5 / 5
Advertisement
Table of Contents
Need help?
Do you have a question about the NS3552-16P-2T-2S and is the answer not in the manual?
Questions and answers