Sound Effects; External Music Device - Panasonic SC-HC302 Operating Instructions Manual

Sound effects

1
Press [SOUND] repeatedly to select the sound
effect.
2
Press [R, T] to select the setting and then press
[OK].
MY SOUND
PRESET EQ
BASS
TREBLE
D.BASS
SURROUND
CLEAR-MODE
DIALOG
Note:
Changed settings will be kept until it is changed again, unless
otherwise indicated.
Saving the sound settings
You can save the current sound effects (up to
3 combinations).
Preparation
Select the sound effects.
1
Press [SETUP] to select "SAVE MY SOUND".
2
Press [R, T] to select a sound setting number and
then press [OK].
"SAVED" is shown.
The new setting replaces the one existing in the same
sound setting number.
To recall the setting
1
Press [SOUND] to select "MY SOUND".
2
Press [R, T] to select the sound setting number
and then press [OK].
12
"SOUND 1", "SOUND 2" or
"SOUND 3" (~below)
"HEAVY", "SOFT", "CLEAR",
"VOCAL" or "FLAT"
–4 to +4
–4 to +4
"ON D.BASS" or "OFF D.BASS"
"ON SURROUND" or
"OFF SURROUND"
"ON CLEAR-MODE DIALOG" or
"OFF CLEAR-MODE DIALOG"

External music device

You can play music from an external music device.
Preparation
• Switch off the equaliser (if any) of the external music
device to prevent sound distortion.
• Decrease the volume of the system before you connect
or disconnect the external music device.
Audio cable
(not supplied)
1
Connect the external music device using an audio
cable (not supplied).
Plug type: Ø 3.5 mm stereo
2
Press [RADIO/AUX] to select "AUX".
3
Play the external music device.
To adjust the input level
1
Press [SOUND] repeatedly to select
"INPUT LEVEL".
2
Press [R, T] to select "LOW" or "HIGH" and then
press [OK].
Note:
•
The default setting is "HIGH".
•
Select "LOW" if the sound is distorted during "HIGH" input
level.
•
Read the operating instructions of the external music device
for details.
•
Components and cables are sold separately.
AUX IN auto play
The system will automatically switch to AUX source when
it detects the signal from an external music device.
This function also works in standby mode.
1
Press [SETUP] repeatedly to select "AUX-IN AUTO
PLAY".
2
Press [R, T] to select "ON" and then press [OK].
To cancel, select "OFF".
Note:
•
The default setting is "OFF".
•
When the function is switched off and every time you switch
to AUX source, "AUX-IN AUTO PLAY IS OFF" will be shown
once.
•
This function does not work when the volume of the external
music device is low, increase its volume.
•
Stop or pause the external music device before you change
to other music source or to standby mode so as to prevent
the automatic switch to AUX source.