D-Link AirPremier DWL-2210AP Quick Installation Manual page 2

Connecting the DWL-2210AP to Your
Network
There are two methods of powering the DWL-2210AP. The power adapter can plug directly
into the unit or plug into the PoE (Power over Ethernet) base unit. To connect power
directly to the DWL-2210AP, please follow the steps on this page. To use the PoE base
unit, please follow the steps on the next page.
Connecting Power Directly to the DWL-2210AP
A. Connect the power adapter to the receptor at the back panel of the DWL-2210AP.
Plug the other end of the power adapter to a wall outlet or power strip. The Power LED
will turn ON to indicate proper operation.
B. Insert one end of the Ethernet cable to the
DWL-2210AP and the other end of the Ethernet cable to an Ethernet Broadband
Router (i.e., D-Link DI-604) or Switch (i.e., D-Link DSS-5+). Note: You also have the
option of connecting the DWL-2210AP directly to the computer that will be used for
configuration. The LAN LED light should illuminate to indicate a proper Ethernet
connection. (Note: The Ethernet Port on the DWL-2210AP is Auto-MDI/MDIX. This
allows you to use a straight-through or crossover Ethernet cable to connect to the
Ethernet port on the DWL-2210AP.)
C. The DWL-G650 AirPlus Xtreme G
AirPlus Xtreme G
DWL-2210AP, using their default wireless settings. Computers with 802.11b wireless
adapters can also connect to the DWL-2210AP.
™
™ Wireless PCI Adapter will connect, right out of the box with the
Ethernet port on the back panel of the
Wireless Cardbus Adapter and the DWL-G520
2