Part Names; Installation - Kenmore 405.35016510 Use & Care Manual

16"/18" wall fan 3speeds,oscillation switch , safetymetalguard
Table of Contents

Advertisement

Available languages

Available languages

PART NAMES

Retaining
Nut
3 Screws
Wall
mounting
bracket
Hardware
kit
GUARD & FAN BLADE ASSEMBLY
1. Unscrew and remove the spinner clockwise (or obtain
from parts bag), and the plastic nut counterclockwise
(Fig. 2). You may have to hold the shaft in place with
one hand to unscrew the spinner with the other. Mount
the rear guard against the motor face so that the pin
at the motor face bottom fits through the tear drop
hole in the rear guard mounting ring. When correctly mounted the set of two
tabs on each side of the motor face will also fit through their designated holes
in the mounting ring, and the rear guard will rest flat and evenly on the motor
face. Screw the plastic nut back onto the motor face to secure the rear
guard in place. Fig. 1
2. Mount the blade set onto the motor shaft through the center hole in the blade
set. Insert the retaining pin on the motor shaft into the slots in the Blade set
core. Turn the spinner counterclockwise onto the shaft to tighten the blade set
into place. Fig. 3
3. Open the five latch clips on the rear guard. Align the logo on the front guard
so that it will read horizontally. Insert the edge of the front guard into the
fixed clip at the bottom of the rear guard. Use the five latch clips to secure the
two guards together. Fig. 4
Fig.2

INSTALLATION

The fan must be installed into a wall stud or into a stable
wooden upright standing vertically from the floor.
CAUTION: To prevent the fan from falling down, be sure
to install it into a wall stud. Do not install it only into a
wall surface not backed with a stud.
Blade Set
Fig.3
2
Fig.1
Fig.4

Advertisement

Table of Contents
loading

This manual is also suitable for:

405.35018510

Table of Contents