PART NAMES
1. Body
2. Pedestal
3. Base
4. Wing Screws
5. Power cord
PARTS ASSEMBLY
A. Pedestal Assembly
• Line up the front and rear pedestal assembly pieces and firmly
snap together. Fig. 1. The rear piece has a screw hole opening
near the top.
B. Base Assembly
• Connect the two pieces of the base together by inserting the
four pins of the rear half B into the four channeled holes for
them in the front half A . Fig. 2.
C. Securing the Pedestal to the Base
• Align the 3 screw holes on the bottom of the pedestal with
the 3 holes on the base and insert pedestal into base. Fig. 3.
• Secure the base assembly to the pedestal by inserting and
tightening the 3 wing screws into the 3 holes located on the
bottom of the base (Fig. 4).
D. Securing the Tower Fan to the Pedestal
• Carefully turn the fan on its side and place on a table. Feed
power cord through the center of the pedestal and base
assembly.
• Insert the pedestal over the base of the fan body so that the
tabs in the fan body base fit into the slots for them in the
pedestal. Rotate the pedestal slightly to secure the tabs into
the slots. When correctly secured the screw hole in the fan
body base will be aligned with the screw hole in the pedestal.
Fig. 5.
• Secure the pedestal to the fan body base by inserting and
tightening a wing screw into the attachment hole. Fig. 6
2
Fig. 1
Pedestal Assembly
Fig. 2
A
B
Base Assembly
Fig. 3
Positioning
Pole
Positioning
Hole
Fig. 4
Fig. 5