Speed Adjustment; Maintenance Instructions; Fuse Replacement - Kenmore 405.35016510 Use & Care Manual

Installing the mounting bracket
Fix the supplied mounting bracket firmly to the wall
using the three screws.
NOTE: The bracket should be positioned at least
14 inches from the ceiling and at least 12 inches
from adjoining wall.
IMPORTANT: Make sure the Mounting Bracket is
installed into a wall stud. Otherwise, use wall
anchors to provide proper support.
Installing the stand
Mount the stand on the bracket by inserting the
bracket catch into the slot on the stand.
Fix the stand to the bracket with the retaining nut.
NOTE: If the retaining nut does not pass through the
hole in the bracket, push the stand downwards until
it is fully mounted onto the bracket.

SPEED ADJUSTMENT

Adjust to the desired speed by pulling switch cord (A).
The control dial will click to a different position with
each pull of the cord.
Off---Off Low---Low Med---Medium High---High
OSCILLATION CONTROL
Pull switch cord B to start and stop fan oscillation.
To adjust vertical air direction, lightly push on the front
guard to tilt either up or down.

MAINTENANCE INSTRUCTIONS

The fan requires little maintenance. Do not try to fix it by yourself. Refer it to
qualified service personnel if service is needed,or call Customer Assistance at
866-646-4332.
1. Before cleaning fan, always unplug it from the electrical outlet.
2. To ensure adequate air circulation to the motor, use a vacuum to keep vents
at the rear of the motor housing free from dust, fluff, etc. Do not disassemble
fan to remove dust or fluff.
CAUTION: To avoid injury from electrical shock, unplug the fan before using a
vacuum cleaner to clean the vents.
3. Wipe the exterior parts with a soft cloth soaking a mild detergent.
Do not use any abrasive detergent or solvents to avoid scratching the surface.
Do not use gasoline or paint thinner as a cleaner.
4. Do not allow water or any other liquid into the motor housing or interior parts.

FUSE REPLACEMENT

1. Grasp the plug and remove it from the receptacle or other outlet device.
Do not unplug by pulling on the cord.
Wall stud
3
Speed Adjustment
Oscillation Control