Kenmore 405.35016510 Use & Care Manual page 5

16"/18" wall fan 3speeds,oscillation switch , safetymetalguard
Table of Contents

Advertisement

Available languages

Available languages

2. Open the fuse cover. Slide open the fuse access
cover on top of power plug towards blades.
3. Remove the fuse carefully. Push the fuse from the
other side or turn the fuse holder over to remove the fuse.
WARNING: Risk of fire. Replace the fuse only with 2.5 A, 125
Volt fuse.
4. Close the fuse cover. Slide closed the fuse access cover on top of the
power plug.
WARNING: Risk of fire. Do not replace power plug. It contains a safety
device (fuse) that should not be removed. Discard product if the power plug
is damaged.
NOTICE:
1. After replacing fuse, do not at first operate at full speed. Doing so may cause
product malfunction or damage.
2. If the fan doesn't seem to operate properly after fuse replacement, check to
make sure that the fuse was inserted correctly.
CLEANING
1. Be sure to unplug fan from the electrical supply source before cleaning.
2. Clean plastic fan parts with a cloth or sponge moistened in a solution of mild
soap and water. Thoroughly remove soap film with a damp cloth. Wait for
surfaces to completely dry before running fan.
3. Be sure not to allow water or other liquid to enter the inside of the motor.
4
PRINTED IN CHINA

Advertisement

Table of Contents
loading

This manual is also suitable for:

405.35018510

Table of Contents