Rinse Aid - Thermador DWHD650W Series Use And Care Manual

Rinse Aid

As soon as the low rinse aid indicator
the control panel, rinse aid should be topped off.
The rinse aid is required for stain-free utensils and clear
glasses. Use only rinse aid which the manufacturer
designates as safe to use in domestic dishwashers.
Combined detergents with rinse aid component may be
used with soft to moderately hard water only (0-2 bands
on test strip or up to an °E value of 20). For moderately
hard to hard water (3 to 4 bands on test strip or °E value
of 21 or higher), rinse aid must be used.
Adding rinse aid
NOTICE: To avoid oversudsing or clogging, do not
overfill the rinse aid dispenser
with a damp cloth.
Open the rinse aid dispenser
1.
latch of the lid and pulling it open.
Add liquid rinse aid to the dispenser
2.
Do not overfill. Avoid spilling into air vent hole.
Close the lid. Lid must be fully closed until it clicks in
3.
order to seal.
Wipe up any excess rinse aid that may have puddled
4.
when the dispenser reservoir is full.
This prevents excessive frothing during the next wash
cycle. The indicator light will go out a few moments
after the dishwasher door is shut.
lights up on
8
. Wipe up any spills
9*
by pressing on the
9*
until it is full.
9*
Tip: For easier pouring, remove lid from the rinse aid
bottle.
NOTICE: Do not fill the rinse aid dispenser
detergent. Doing so will damage the dishwasher.
Setting the amount of rinse aid used
The amount of rinse aid to be dispensed can be set from
§ : ‹‹ to § : ‹‡ . Set the amount of rinse aid to be
dispensed to : to obtain a very good drying result.
§ ‹†
Do not change the amount of rinse aid unless there are
streaks or water stains on the utensils. Set a lower level
to avoid streaks. Set a higher level to avoid water stains.
Set the amount of rinse aid as follows:
Open the door.
1.
Press on ON/OFF button
2.
Press the Setup button for 3 seconds until
3.
shown on the display window
Keep pressing the Setup button until the rinse aid
4.
setting, § : ‹† is displayed.
Change the setting with the setting buttons + -
5.
Press and hold the Setup button for 3 seconds.
6.
The chosen setting has now been stored.
Note: Do not change the amount of rinse aid unless
there are streaks (select lower setting) or water stains
(select higher setting) visible on the utensils.
Turning off rinse aid indicator
Proceed as described in the section "Setting the amount
of rinse aid used" and set value to
indicator is now turned off.
NOTICE: Using no rinse aid or setting the dispenser to
: may result in longer cycle times consuming more
§ ‹‹
energy and water. The higher temperatures and longer
cycle times can damage fine china or glassware.
with
9*
.
(
• : ‹‹ is
.
H
P
: . The rinse aid
§ ‹‹
.
15