Installing The Print Server - D-Link DP-313 User Manual

Installing the Print Server

WARNING: Configuration problems may result if the Print
Server is powered up without first establishing
its network connection. Follow this procedure
to avoid complications at the configuration
stage.
1. Confirm proper operation of each of the printers to be connected to
the Print Server.
2. When you have confirmed proper operation of each printer, switch its
power off.
3. Confirm that your wireless network is operating normally.
4. (a) Ad-Hoc Mode
Before initiating set-up procedure for the print server make
sure your wireless PCMCIA card on your PC/Notebook is
set to channel 6 in ad-hoc mode.
After setting is confirmed reboot PC/Notebook to enable
new setting.
Make sure the DIP switch on the print server is positioned
in the ad-hoc mode.
Press the Reset button on the print server for three seconds
or when the LPT1, LPT2 & LPT3 begins to light up
initiating the factory reset.
When factory reset is completed the print server will be set
to default on channel 6.
Note:
When changes are made on the print server's wireless channel it must
correspond to the PC/Notebook channel for direct wireless
communication.
4. (b) Infrastructure Mode
8