EGO ST1520 Operator's Manual page 21

Before each use check for damaged/worn parts
Check the trimmer head, guard and front-assist handle and replace any parts that are
cracked, warped, bent, or damaged in any away.
The line-cutting blade on the edge of the guard can dull over time. It is recommended
that you periodically sharpen it with a file or replace it with a new blade.
WARNING:
sharpening or replacing the blade. Note the location of the blade on the guard and
protect your hand from injury.
Clean the trimmer after each use
See the Maintenance section for cleaning instructions.
WARNING:
cleaning plastic parts. Most plastics are susceptible to damage from various types of
commercial solvents. Use clean cloths to remove dirt, dust, oil, grease, etc.
Tips for best trimming results
(Fig. 13)
◾
The correct angle for the cutting
attachment is parallel to the ground.
◾
Do not force the trimmer. Allow the
very tip of the line to do the cutting
(especially along walls). Cutting
with more than the tip will reduce
cutting efficiency and may overload
the motor.
◾
The cutting height is determined by the distance of the cutting line from the lawn
surface.
◾
Grass over 8 inches (200mm) should be cut by working progressively from top to
the bottom in small increments to avoid premature line wear or motor drag.
◾
Slowly move the trimmer into and out of the area being cut, maintaining the
cutting head position at the desired cutting height. This movement can be either
a forward-backward motion or a side-to-side motion. Cutting shorter lengths
produces best results.
◾
Trim only when grass and weeds are dry.
56-VOLT LITHIUM-ION CORDLESS 15" STRING TRIMMER—ST1520 & ST1520S
Always wear gloves when mounting or replacing the guard or when
Never use water to clean your trimmer. Avoid using solvents when
13
Dangerous
cutting area
Best cutting
area
21