EGO ST1520 Operator's Manual page 16

MOUNTING AND ADJUSTING THE FRONT-ASSIST HANDLE
1. Remove the battery pack from the trimmer.
2. Loosen the four screws in the
handle with the supplied hex
wrench and remove the screws and
the lower clamp from the front-
assist handle (Fig. 6).
3. Refer to Fig.7: attach the front-
assist handle and the lower clamp
onto the shaft and secure them by
pre-tightening the four screws. Turn
the front-assist handle upward
so that it points toward the top of
the rear handle.
4. Adjust the front-assist handle
position so that it is between the
rear handle housing and the joint
of the shaft, as shown in Fig. 8. For
ST1520, adjust the handle position
so that it is between the rear handle
housing and the warning label on
the shaft. The handle should be
adjusted so that your front arm will
be straight when using the trimmer.
5. Use the supplied hex wrench to
tighten the four screws so that the
handle cannot be rotated on the
shaft.
16
56-VOLT LITHIUM-ION CORDLESS 15" STRING TRIMMER—ST1520 & ST1520S
6
Screw
7
8
Front-Assist Handle
Lower Clamp