Bottom Panel - D-Link DFE-904 User Manual

Jacks 1, 2, 3, and 4 are RJ-45 connectors for the hub's network ports. Each is
wired to work with a cable from a network end node or from another hub's
uplink jack.
The Uplink jack is an RJ-45 jack wired for an uplink connection to another hub.
This jack is part of the same circuit as jack 4; never use both of these jacks at the
same time.
Technical Note:
Use the Uplink jack only for a connection to another hub, never for a connection
to an end node. Note that such a connection will require a cross-wired jack (the
kind that is wired for an end node) on the other hub.
Use only standard (straight-through) UTP or STP cables with the DFE-904.
Category 3, 4, and 5 cables are all acceptable for 10 Mbps; only Category 5 and
equivalent cables are acceptable for 100 Mbps. Network cables can be attached
and detached at any time, whether the hub is on or off. Read the relevant
connection instructions in this guide carefully before making connections.

Bottom Panel

On the bottom of the hub are two mounting holes and four indented square
outlines.
The mounting holes, together with the supplied screws and wall anchors, let you
mount the hub on a vertical surface. The holes are diagonally oriented so the hub
can face in any direction. We recommend mounting the hub with its cable jacks
facing down or sideways to help keep dust off the contacts.
8
The difference between the Uplink jack and jack 4 is that the
transmit and receive lines are crossed in jack 4 and
uncrossed in the Uplink jack. If the hub had no Uplink jack,
you would need a special cross-wired cable to make an
uplink connection.