Powering Up - D-Link DFE-904 User Manual

The DFE-904 and connected devices can be powered up in any order. Before
powering up the DFE-904, make sure that —
- the hub is set to work at the speed at which all connected devices will access
the network;
- the AC adapter is designed for the line voltage and the kind of AC outlet used
in your location;
- the adapter provides the voltage, amperage, and polarity required by the hub
(9V DC, 1A, inside positive, outside negative) and has the correct type of
barrel connector for the hub's DC power jack.
Important:
When certain that the power adapter is suitable, plug the adapter into a standard
wall outlet and plug the adapter's barrel connector into the DFE-904's DC power
jack.
When power is applied, the Collision indicator and the indicator for the currently
selected speed will light up. After a few seconds the Collision indicator will go
out and the hub will be ready.
Double-check the input rating of the supplied power adapter
to make sure it matches the line voltage in your area. If it
does not, contact your computer equipment dealer and obtain
a replacement adapter.

Powering Up

17