D-Link DFE-570TX Setup Manual page 8

Step 7
You will be prompted to give the new array a name. Simply type over "New Array" in the
pull-down list in the middle of the dialog. In the example at the right, an array called
"Group1" was added.
Step 8
Next you are asked if you want to use this adapter's protocol information as the primary
address for the array. If this is the primary IP of the machine you want advertised to clients,
select Yes. Otherwise, select No and continue adding the other adapters to the array.
When finished, click OK.
NOTE: When prompted to use an adapter's protocol information, you can only select YES for
one adapter per array. The adapter chosen to use its protocol information will
become the PRIMARY adapter of the array. To change protocol information for the
array, you must change the protocol information for the primary adapter.
NOTE: All available adapters must be assigned to an array. If you do not want load
balancing or failover for a single adapter, assign it to a separate array by itself.
Step 9
When finished configuring the array, close the DFE-570TX Properties dialog and return the
Setup program. Click the finish button to complete the setup.
D-Link Corporation
DFE-570TX Setup Guide
Page - 8 -