ABB TPL65-A30 Operation Manual page 81

Operation Manual / TPL65-A10 / -A30
7 Removal and installation / 7.2 Removing the turbocharger
© Copyright 2018 . All rights reserved.
Ribs (01) not in the middle at the top:
w
Completely remove the bearing casing insulation (02) and place a
u
sling around the bearing casing.
Loosen the fixing screws at the foot.
u
Lift the turbocharger off the engine and set it down to one side.
u
WARNING
Beware of tilting
If support for the turbocharger is not provided or is inadequate, the
turbocharger could tip over during installation or removal and cause a
serious or even fatal injury.
Wear personal protective equipment (PPE).
u
Support the turbocharger at a suitable point.
u
Secure with lifting gear wherever possible.
u
Cover the oil connection.
u
HZTL2482_EN Revision D April 2018