Setting Up The Monitor; Attaching The Stand - Dell D2720DS User Manual

Setting Up the Monitor

Attaching the stand

NOTE: The stand is not installed at the factory when shipped.
NOTE: The following instructions are applicable only for attaching the stand that was
shipped with your monitor. If you are attaching a stand that you purchased from any
other source, follow the set up instructions that were included with the stand.
To attach the monitor stand:
1 Remove the monitor's protective cover and place the monitor with its front facing
downward on it.
2 Use a screwdriver to fully tighten the four screws to the back of the monitor.
3 Insert the stand base blocks fully into the stand slot.
16 | Setting Up the Monitor