D-Link DMP-90 User Manual page 24

(2) How do I set my Parallel Port to ECP?
The DMP-90 requires your Parallel port to be set to ECP to function
properly. Most computers will allow you to change this setting in the BIOS.
Please note that most users are not comfortable with changing BIOS
settings and D-Link does not recommend that you change your BIOS
settings as it may cause your computer to stop functioning. D-Link
recommends that you contact the maker of your motherboard or computer
for detailed instructions on how to set your Parallel port to ECP mode.
If you are an advanced user and are comfortable with making the change,
most BIOS' will have a specific line item pertaining to Parallel Port Mode.
Find this line and follow the directions in your BIOS, or provided by your
computer/motherboard manufacturer, to change this setting to ECP. It is
normally a simple matter of toggling the Parallel Port Modes using the
PgUp/PgDn keys to find the right setting. Once you have made the
change, Save and Quit your BIOS set up program to reboot your computer.
Please note that once your computer reboots, Windows 95, 98, and 98SE
will find the new ECP Parallel port and attempt to install the drivers. You
will need to provide your Windows installation CD if prompted. Once you
have completed this change, follow the directions in (1) How can I
determine if my Parallel port is set to ECP? to double check your Parallel
port settings.
19