Table of Contents
Advertisement
NI CVS I/O Accessory
This accessory is unshielded.
Note
•
CVS I/O Accessory and 3 meter 44-pin D-SUB male to 44-position D-SUB female
cable (part number 783327-01)
•
CVS I/O Accessory and 0.5 meter 44-pin D-SUB male to 44-position D-SUB female
cable (part number 783328-01)
DIN Rail Kit (part number 781740-01)
Serial cable (part number 182845-01 for 1 meter cable, part number 182845-02 for 2 meter
cable, or part number 182845-03 for 3 meter cable)
Software Options
Use the following software to develop applications with the NI CVS-1458RT.
NI-IMAQdx 14.0 or later driver software, included with NI Vision Acquisition Software
August 2014
One of the following options for developing machine vision applications:
•
NI Vision Builder for Automated Inspection (Vision Builder AI) 2014 or later
•
LabVIEW 2014 or later, LabVIEW Real-Time 2014 or later, and the NI Vision
Development Module 2014 or later
Software for using and reconfiguring the NI CVS-1458RT FPGA I/O. Different
configurations are referred to as hardware personalities, and are defined by bitfiles.
•
LabVIEW FPGA Module 2014 or later—You must install the LabVIEW FPGA
Module to reconfigure the default personality of the NI CVS-1458RT FPGA.
•
NI-IMAQ I/O 14.0 or later driver software, included with NI Vision Acquisition
Software August 2014—NI-IMAQ I/O is required to use the default personality of the
NI CVS-1458RT in LabVIEW, or to reconfigure the default personality of the
NI CVS-1458RT I/O in the LabVIEW FPGA Module.
NI CVS-1458RT Getting Started Guide | © National Instruments | 3
Advertisement
Table of Contents
